OVERSIZE LOAD
Active member
250 EFI first time out this season & it's running hot reading hot on the guage & siren going off. water pressure is withing specs 3 psi @ idle & 13 psi @ 4k rpm. when I pulled it back to idle it would cool back down.
-
Welcome to the Checkmate Community Forums forums.
» Interact with over 10,000 Checkmate Fanatics from around the world!
You are currently viewing our boards as a guest which gives you limited access to view most discussions, articles and access to our other FREE features.
By joining our free community you will be able to:
» Post topics and messages
» Post and view photos
» Communicate privately with other members
» Access our extensive gallery of old Checkmate brochures located in our Media Gallery
» Browse the various pictures in our Checkmate photo gallery
Registration is fast, simple and absolutely free so please, join our community today!
If you have any problems with the registration process or your account login, please contact support by clicking here or by using the"contact us" link at the bottom of the page.
running HOT!!!
- Thread starter OVERSIZE LOAD
- Start date
OVERSIZE LOAD
Active member
going out now to pull the impeller & T stats, I hope I can find them today.
OVERSIZE LOAD
Active member
well I replaced the impeller & checked the thermostats in hot water & they open, so it's not there. anyone have anymore suggestions?
thanx, Steve T.
thanx, Steve T.
Big Red
Well-known member
Did you run the boat in the lake after that
OVERSIZE LOAD
Active member
YUP.
OVERSIZE LOAD
Active member
prob. found just in time to make it out onto Norman. the water temp. gauge or temp sensor went bad the exact same time the ecu detected water in the gas. so we were chasing a overheating gost. the motor was not running hot after all.