boatn70
Well-known member
So I am working on a Mercruiser Throttle handle....4000 MPC gen 2 control on 350 mag mpi.
when first engaging into gear the handle is very hard to move, almost feels abrasive. Once forward enough in "throttle" position it feels easier. Reverse is similar but it has less travel there anyway.
I pulled the control assbly off the side of the boat, opened it up, grease looks good, everything seems clean, no obvious wear marks from something rubbing or out of alignment. Took cable out completely, from the motor end I can move everything freely, cables feel like they travel nicely. Reconnect and friction. Without cables connected inside control the control seems to be ok.
I have the installation manual and there is a "Control handle friction adjustment nut" that is noted to be set from the factory. I did not adjust that nor do I see what it will adjust.
Thats my issue right now.
Does anyone here have some experience with this and can offer some advice for me??
Thanks
Kevin
when first engaging into gear the handle is very hard to move, almost feels abrasive. Once forward enough in "throttle" position it feels easier. Reverse is similar but it has less travel there anyway.
I pulled the control assbly off the side of the boat, opened it up, grease looks good, everything seems clean, no obvious wear marks from something rubbing or out of alignment. Took cable out completely, from the motor end I can move everything freely, cables feel like they travel nicely. Reconnect and friction. Without cables connected inside control the control seems to be ok.
I have the installation manual and there is a "Control handle friction adjustment nut" that is noted to be set from the factory. I did not adjust that nor do I see what it will adjust.
Thats my issue right now.
Does anyone here have some experience with this and can offer some advice for me??
Thanks
Kevin