• Welcome to the Checkmate Community Forums forums.

    You are currently viewing our boards as a guest which gives you limited access to view most discussions, articles and access to our other FREE features.
    By joining our free community you will be able to:

    » Interact with over 10,000 Checkmate Fanatics from around the world!
    » Post topics and messages
    » Post and view photos
    » Communicate privately with other members
    » Access our extensive gallery of old Checkmate brochures located in our Media Gallery
    » Browse the various pictures in our Checkmate photo gallery

    Registration is fast, simple and absolutely free so please, join our community today!

    If you have any problems with the registration process or your account login, please contact support by clicking here or by using the"contact us" link at the bottom of the page.

new here, what ya think of the boat and rooster tail?

Top Gun

New member
1988 Starliner openbow
V6 225+hp

checkm1.jpg
checkm2.jpg
checkm3.jpg

checkm4.jpg
 
so your saying no rooster tail = more speed?
With the rooster tail 70mph
motor trimed down (no rooster tail) 65mph
 
i'm not an outboard guy , but that don't totally make sense.how about just a minute amount of tail ,so that you are using more of the thrust to move you foward than just blowing it in the air. have you tried to prove/disprove this while using gps ?
 
that's what I mean. If I run no tail at all the boat sits lower in the water, but with about 2 foot of tail it runs faster because less boat is in the water.

The 15-20 foot tail is all show and lots of fun.
biggthumpup.gif
 
First off, Hubert, a rooster tail is that fan of water being thrown up by the engine behind the boat in the photos above (looks kind of like the profile of a rooster's tail). With regards to the statement of more speed in the boat, I think what 175checkmate means is that either 1) the trim is too high for maximum speed with your current setup or 2) the boat needs more engine setback so that it doesn't need so much trim to carry the bow. Either way a high rooster tail is wasted energy (that could be used to push the boat faster) compared to a boat with proper setup & trim. Since Checkmates are typically heavier boats that need a good bit of setback to lift the bow without excessive trim, it's probably the later. Mine has 8" of setback and it still throws a pretty good rooster tail (it does look cool though). It probably needs about 15" (Starliners probably need a similar amount of setback to get best speed with neutral trim, in fact an open bow is probably more nose heavy).
 
Back
Top