Wanted: 5" manual jack plate for Enticer

[204.enticer]

Looking for a manual jack plate for my Enticer. I would like a cnc one but would consider others. let me know what you have. Email me at kris.ostlere@gmail.com or phone (204)226-0581. Thanks.

Kris

 

[DropTop5.0]

I may be mistaken but wouldn't your desired jackplate be dependent upon the motor you are running? Are you running a late model Mercury?

 

[204.enticer]

I thought the jack plates were drilled for multi application. Running an 2002 mercury 115. Can anyone confirm?

I may be mistaken but wouldn't your desired jackplate be dependent upon the motor you are running? Are you running a late model Mercury?

 

[Ramifications]

I think most are setup for multi engine application, but I would confirm your make/model with the jack plate make/model prior to purchase. Not matching the engine mounting plate would be a PIA, but not matching the holes through transom is a big problem

 

[teamhart2]

I had some old non standard holes in my transom from my old suzuki, just drilled new holes in the jackplate to match up with those since I wasnt going to drill more holes in my fairly newly replaced transom, prolly not covered under warranty but stayed in the middle of the plate so I figure itll hold.

 

[Enticer1]

Do It

Kris, I put a CMC plate on my Enticer and it was the best bang for the buck of any change I made.